The MAX3221EIDBR is a single driver, single receiver RS-232 solution operating from a single VCC supply. The RS-232 pins provide IEC 61000-4-2 ESD protection. The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. These devices operate at data signaling rates up to 250 kbit/s and a maximum of 30-V/μs driver output slew rate.
Flexible control options for power management are available. Auto-power down disables driver and charge pump when the receiver is disconnected or the remote driver is power down. The drivers can be manually enabled or disabled. INVALID output goes low when receiver input is unconnected or power off.
MAX3221EIDBR Feature
ESD Protection for RS-232 Pins
±15-kV Human-Body Model (HBM)
±8 kV (IEC 61000-4-2, Contact Discharge)
±15 kV (IEC 61000-4-2, Air-Gap Discharge)
Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU v.28 Standards
Operates With 3-V to 5.5-V VCC Supply
Operates up to 250 kbit/s
One Driver and One Receiver
Low Standby Current: 1 μA Typical
Accepts 5-V Logic Input With 3.3-V Supply
Auto-Power-Down Feature Automatically Disables Drivers for Power Savings
Alternative High-Speed Device (1 Mbit/s)
MAX3221EIDBR(Picture: Diagram)
全部产品分类
FPGA / CPLD
Memory内存
MOS / 晶体管
MCU / 单片机 
DSP / 处理器 
OCEP / 光耦 
二三级管 
其他优势产品 
